I have a 2007 Jaguar X Type. Sovereign Sci. British racing green. 2.0 diesel. Love it. I am changing the right rear wheel bearing and had to cut off the hilt heads as they were stripped so bad. Any ideas on how to remove the studs. I am so close to completion I can taste it. I have sprayed the with WD 40 and have vise grips.

 

Welcome to Jaguar Forums Gordon,

Good to have you with us.
I've copied your post to the X Type section for a better response, you can find it here https://www.jaguarforums.com/forum/x...-studs-217332/
Enjoy the forum.

If you haven't done so already you should add your car details to your signature to help others to help you.
If you need help with getting around and using the forum follow this link for some help Forum Help

 

Welcome to the forums Gordon,

Good to have you with us.

I can see you've already found your way to the X-Type forum with this question so there's no need for a link to it from me. The 'HOW TO' thread at the top is a good place to start for information on regular issues.

Please add vehicle details to your Signature to help others to give relevant advice. Go to the User CP button on the left of the top menu bar, then Settings & Options under Your Control Panel. Select Edit Signature and enter the details.

You can also visit the UK & Eire Region forum by following this link https://www.jaguarforums.com/forum/uk-eire-68/ to find other members in your region.

Enjoy the forums.

Graham

 

Welcome aboard Gordon.

 

Hello, Gordon,
Welcome to the forums from ElinorB.
(';')

 

Welcome to the Forums.

 

Welcome to the forums.

 

welcome to the forum - enjoy!!!