Up for sale here is a complete intake kit:
(original cost) not counting shipping and R&D

($395) 92mm ProM maf already wired. existing wires are labeled to attach to stock connector wires. You keep both connectors so you can go back to stock in 5 minutes.

($80) IAT sensor plumbed into intake

($$Custom) 4" to true 3.5" intake. Hood still closes easily with 3.5" 90 smooth sweep bend into the TB. There is no better flowing XJR intake on the planet

($100) Catch can

Heat shield-so it is a cold air only intake

($376 new) Snow Stage II Water/Meth injection running at 375 ml/minute

I would like to sell the above as one sale for $600, since it works best this way. This intake paired with the water injection before the TB will gain you no less than 2 psi of boost, more likely closer to +3 psi.

I'm going to try to sell the above as a complete set for 1 week before parting it out

First $600 shipped takes all of the above. If interested I can throw in a ported set of intake manifolds too. PM me if interested and it is yours.


I also have a +1.5-1.7 lb aluminum upper pulley available for $150 delivered. the surface is grippier than most aluminum and it will not slip.


I am going to keep the maxbore TB and ported elbow and ported 5th gen blower on the car since it is running perfectly, so if/when I sell it all will be perfect for the next owner.


If anyone wants to buy the whole thing for $600 and then part it out themselves, I am happy to do it that way too

 

I *might* get that maf from you.....

 

And I still have the remote Nitrous bottle opener

 

Ooooh I forgot about that. A lot depends on if I pick this *new* car up

 

I'll claim dibs on the intake and possibly the Pro M(if Michael doesn't buy it), if it gets to parting out.

Thank you sir!

Chris

 

I might be interested in the water / meth kit if you decide to part it all out. Let me know.

 

OK,

I'll let this go a week, then I'll be happy to part it out, you guys have dibs.

OR someone can buy the whole thing and they can part it out.

 

WD, I just sent you a PM..
Thx

 

I responded to your PM


Still available

 

Would the pulley fit an 05 STR? If so, does it use the stock belt?

 

It is an Eaton still right? The pulley should be the same and if it for some reason did not fit, I'd give a full refund. I'm not sure if it can use a stock belt or not, best to post and ask some other STR owner to confirm.

 

OK,

gonna start parting it out. Rakka gets the water injection.

Who wants the MAF and intake?

 

all sold