Hey everybody, I was hoping somebody here could give me some pointers on getting my 3.0 v6 s type automatic back up and running.

I was driving the car about a week ago when the engine suddenly cut out and would not restart, the engine will turn over fine and the fuel pump seems to be working okay however after removing one of the spark plugs I can see there appearers to be no spark, I have pulled every fuse relevant to the Ignition system (engine bay/ drivers side and trunk) All have continuity, I have also checked the inertia switch which is pushed in.

There are no messages on the dashboard however when I switch the electric on the engine/ oil lights are on.

Any advice on where to go next would be much appreciated, Thanks everybody.

 

May not be the only possibility but perhaps the CKP (see my sig)? I think the PCM times spark from it.

 

Thanks mate, I'll have a look... Do ypu know if there is any way to test the sensor?