hi guys.


anybody know the most straight forward way to get the gearbox tunnel out.


it doesn't appear as simple as on the old xj40.


I need to get the gear selector out to change the electric module on the side of it......


cheers

 

it's been described in earlier threads but you might want to download JTIS from the stickies for the complete procedure

 

how do I do that?

 

Just follow the instructions.

https://www.jaguarforums.com/forum/x...archive-65998/

 

Look at this other forum thread (view its post# 1) It has instructions and photos on how to remove the gear shifter:

https://www.jaguarforums.com/forum/x...cklight-75330/

Jim Lombardi

 

10 minutes job. You need a 6 or 8 mm key, a cross screwdriver and a torx (I forget the size, 30-40 I think). Most tricky is to pull out the shifter leather surround trim, usually two credit (or debit?) cards are recommended to take it out.

 

Here is the JTIS information on gear shifter R&I - 4 PDF files:

Selector Lever indicator Assembly 44.15.14

https://www.dropbox.com/s/s5a3lesxkb...ly%20R%26I.pdf

Selector Lever Knob R&I 44.15.06 (Transmission Selector Lever Knob)

https://www.dropbox.com/s/pmm51788si...ob%20R%26I.pdf

Selector Gate Finish Panel 76.25.24 (J gate Finisher)

https://www.dropbox.com/s/fhbs5kakti...el%20R%26I.pdf

Floor Console Finish Panel 76.47.26

https://www.dropbox.com/s/b0gsja74j3...el%20R%26I.pdf

Jim Lombardi

 

all sorted, just two screws at the rear and two torques up front.......ta

 

This came in handy today, kudos sirs.