Hello,
Can anyone tell me what holds the front of the console in place, I have the slope out & everything else is done but I can't figure out the front. I also have the side vent panels already off.
Thanks Bill

 

Yours is a facelift, so I may be incorrect. However, I think (like the pre-facelift) that you have to remove the aircon heater control knobs (just pull them) and then undo the round 'nuts' threaded round the knob stems, and then you can pull off the trim piece with the heater temp and fan speed markings, and this reveals two screws holding the console at the front.

The round 'nuts' are not easy to undo as you need a special tool, or two small screwdrivers and lots of dexterity!

Greg

 

Greg,
I read that in a manual for the older ones, so i gave a little pull & the knobs didn't move. I will try a little harder today & report back

 

The knobs definitely pull off.

Greg

 

Thank you Greg,
That was it, the first time I tried, I was a little tenative when I pulled, but today I gave them a good yank & they came off in one piece.. no problem
I will be starting a build thread in the next couple of days.