Ahoyhoy....................................lve sprung for a new injector harness for my 1982 V12. lve seen posts about folks that have secured the harness to the fuel rail to keep it out of death valley. So, before i go berserk with the zapstraps is there a ''preferred method'' of layout and attachment (picture would be terrific), or is it a case of anything is an improvement over bottom o valley

Cheers.

 

Just cable tie it to the fuel rail, the only thing to watch out for is to make sure the leads from the main harness to the plugs are not too bent over, as that will stress them over time.

 

Mine went between the underside of the inlet manifolds and the camcover/s.

Hidden except for the pigtails, and NO strain, as Greg said, that will bite ya bad in a few months.

I wrapped mine in Hot Rod Header wrap, just because.

 

Thanks as always Gents!