I searched through a lot of threads about the ABS pump, but none gave me the information I need.

I want a "simple" how-to that shows me what it takes to remove my ABS pump motor, module, and pressure block so I can replace the whole assembly WITHOUT TAKING IT APART.

I want off and on, out and back in. What to watch out for and what not to do.

Obviously, the brake lines will need disconnecting and reconnecting after re-installation. I have R&R'd my module several times and didn't have any issues of brake fluid loss or air in the lines from just removing the 3 or 4 on the outboard side to could get the module out. This time I'm gonna replace the entire 3 part assembly.

Any help (especially with pics) would be appreciated.

Ken

 

You have a private message.