I feel so inadequate, I cannot figure out the correct bit?

I need to remove it to replace a part.

 

First, your gonna hafta find a glove box big enough to fit two people into.

 

Assuming this is a serious question, you're going to have to come up with a better photo.

I haven't seen anything like that since the early Apollo missions were checking the lunar surface for potential landing sites.

Graham

 

I haven't laughed this hard all day!

 

picture sucks, can't get the camera to focus so close so I am hoping someone has done this before.

 

Is it the two fixings at the top of the left and right of the glovebox lining sides? The right hand side is arrowed here:

Jaguar XK8 - Glovebox.pdf

If so, you need a Torx T-20 bit to remove them.

Graham

 

To remove the glove box completely, you need to pull off the wood section which has the air bag behind it and undo the 4 screws you see at the top of the glove box, then unscrew all the hinge screws from underneath, the whole thing then comes out

 

With some difficulty, I should imagine!!

I needed a smile today.

Thanks,

Languid.

 

as soon as I saw this question I new somone would beat me to it..good answer..

 

Thanks, that is it.

Glad you all enjoyed the little play on words.