Side mirrors housing remove/replace?
#1
#2
based on earlier X300
The chrome pieces come off without the whole unit and don't need to come off if removing whole assembly
Buuuuuuuuuuut
No need to remove interior door side panels
with a plastic putty knife carefully pry off the fwd widow corner plastic triangle
It has plastic hocks on the inside you will probably break in the process but is also glued in place with anti rattle glue that can be reused
There is one nut about 15 mm and the threaded shaft on the mirror won't spin
The electrical connector is tucked into the main rubber seal so just tug out
The chrome pieces come off without the whole unit and don't need to come off if removing whole assembly
Buuuuuuuuuuut
No need to remove interior door side panels
with a plastic putty knife carefully pry off the fwd widow corner plastic triangle
It has plastic hocks on the inside you will probably break in the process but is also glued in place with anti rattle glue that can be reused
There is one nut about 15 mm and the threaded shaft on the mirror won't spin
The electrical connector is tucked into the main rubber seal so just tug out
Last edited by Lady Penelope; 01-30-2019 at 03:26 AM.
The following users liked this post:
3timejag (01-30-2019)
#3
#4
#5
Thread
Thread Starter
Forum
Replies
Last Post
Jag2018
XE ( X760 )
5
04-09-2018 10:49 AM
Maciek
XJ XJ6 / XJ8 / XJR ( X350 & X358 )
4
10-24-2017 11:18 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)