Hi, i have a 2002 jaguar x type 2.5 and while changing my plugs and coils i must of bump and hit the throttle position sensor connector because the wires came out of the connector and the connector was smashed. When i started the car the check engine like came on and the red explanation mark was on. The codes that my reader gave me was a p01222 and p0121. It said something about low voltage to throttle position sensor. The car is idling real high. I ordered another denso tsp that had a connector with it. My question is the wires that came out of mine are black/yellow - yellow - purple - and orange. The one i ordered has black/yellow - yellow - red - orange. So would i just crimp my purple to the the red?

thank you.

 

https://www.jaguarforums.com/forum/x...wiring-120889/

 

Thank you. So which wire is the ground, power, and signal wire?

 

Bottom right side of the pic =

2014-04-28_0945

 

thank you guys. I hooked up the new connector and plugged it in to my tps and now the check engine light is gone, the limp mode light is gone, and my rpms are back to normal.